Email this to a friend
 
posted on June 18th 2014, at 13:49
by lunarg
From a logging point of view, it's interesting to have your clock set up correctly on your Cisco switches. Your switch should have these capabilities, but network admins usually "forget" to set these up.

To configure these, you need to have privileged access to your switch using SSH/telnet/console. The following works on any device running iOS (i.e. switches and routers).

Time zones are expressed as a name, followed by an offset. The offset indicates the number of hours from UTC, expressed as -hour or +hour. To know the offset for your time zone, you could look at the World Time Zone map.

In my case, for Central European Time, I would set it to this:

SW(config)# clock t  ...

Send a link to this post to yourself or a friend.

Send to e-mail:
Your name:
Your e-mail:
Captcha:
Type the letters and numbers as shown.
/get/captcha/1573631110
Not readable? Get another.
 
Information entered is solely used for sending a one-time e-mail, and is not retained and/or passed on to a third party.