Email this to a friend
posted on November 25th 2015, at 10:58
by lunarg

Resetting a HP 1810-24 or -24G to factory defaults is easy:

  1. With the switch powered on, using both ends of a paperclip (or two separate paperclips), press and hold down the Reset and Clear buttons.
  2. Release the Reset button, but keep the Clear button held down.
  3. When all three mode LEDs (Act, FDx, and Spd) begin to blink, release the Clear button as well. When the self-test completes, the switch will be reset to factory defaults. Its IP address will be obtained through DHCP, or if there's no DHCP, it will be set to The password will be blank.

Send a link to this post to yourself or a friend.

Send to e-mail:
Your name:
Your e-mail:
Type the letters and numbers as shown.
Not readable? Get another.
Information entered is solely used for sending a one-time e-mail, and is not retained and/or passed on to a third party.
« July 2024»
« Smith & Wesson - the original point and click interface »